Effects of the grit-blasting of titanium abutment on the retention of implant-supported prostheses Integrative review
Résumé
Introdução: As próteses suportadas por implantes baseiam-se no titânio e nas suas ligas devido às suas propriedades mecânicas e biocompatibilidade. . A adesão entre o pilar e o material de revestimento em próteses é um desafio, levando a tratamentos de superfície para aumentar a resistência de união.
Objetivos: O objetivo deste estudo foi realizar uma revisão integrativa sobre o jateamento dos pilares de tiânio com partículas abrasivas para aumentar a retenção de cimentos de resinas e consequentemente de estruturas protéticas.
Materiais e Métodos: A pesquisa bibliográfica foi realizada na PubMed para selecionar artigos publicados em língua Inglesa entre janeiro de 2013 a maio de 2023. As seguintes palavras-chave foram utilizadas: surface" AND "abutment" AND "titanium" AND "sand blasting" OR "grit blasting" AND "retention" OR "adhesion" OR "resin cement".
Resultados: A pesquisa identificou 113 artigos, dos quais 17 foram considerados relevantes. Os resultados revelaram maiores valores de rugosidade (0,6-2,3 µm) dos pilares de titânio após jateamento quando comparados aos pilares sem modificação de superfície (0,04 µm).
Discussão: O aumento da rugosidade das superfícies de titânio aumentou após o jateamento, resultando numa maior retenção em comparação com as superfícies maquinadas sem tratamento.
Conclusão: Superfícies maquinadas de pilares de titânio revelaram uma baixa rugosidade o que resulta em baixa retenção para os cimentos de matriz de resina. Após o jateamento, a rugosidade aumentou e os aspetos morfológicos das superfícies estabeleceram um embricamento mecânico dos cimentos de matriz resinosa levando a altos valores de resistência à união. Introduction: Implant-supported prostheses are based on titanium and its alloys because of their mechanical properties and biocompatibility. Adhesion between abutment and veneering material in prosthetics is a challenge, leading to surface treatments to increase bond strength.
Objectives: The main aim of this study was to perform an integrative review on the grit-blasting on the titanium abutment surfaces to enhancing their retention to resin cements and prosthetic structures
Materials and Methods: The search was conducted in PubMed (through the National Library of Medicine) for articles published from January 2013 to January 2023 using the following combinations of search terms: "surface" AND "abutment" AND "titanium" AND "sand blasting" OR "grit blasting" AND "retention" OR "adhesion" OR "resin cement".
Results: The search identified 113 articles, of which 17 were considered relevant for this study. Results showed higher roughness values (0.6-2.3 µm) of the titanium abutments after grit-blasting when compared to abutments without any surface modification (0.04 µm).
Discussion: Increased roughness of titanium surfaces increased after gritblasting resulting in higher retention compared to untreated machined surfaces.
Conclusions: Machined surfaces of titanium abutments without surface modification revealed low roughness and non-retentive regions for resin-matrix cements. After grit-blasting, roughness increased, and the morphological aspects of the surfaces established a mechanical interlocking of the resin-matrix cements leading to high bond strength values. The combination of grit-blasting and other physical surface methods can enhance the retention of titanium abutment to resin cements adhered to the prosthetics.